
Within the AUTOMIC system the delegates´ unit AMic serves as a microphone unit and is equipped with a button to switch the microphone on and off or (depending on the operating mode) for requests to speak. A loudspeaker is included to each unit for decentralised sound reinforcement.
The black/grey housing consists of impact resistant plastic and if desired, the housing upper part can be supplied in other colours. So it is relatively simply possible to give to the equipment your personal note, or adapt it to your interior.
The operating modes are managed by the ACon central control unit, the APad microphone switchboards or the MicControl software. The microphone units will be connected with one single cable for voltage supply, audio and control signals (Daisy Chain).
Complies with international standard IEC914
Connections
Features
Housing
Professional electret microphone with ON status light ring indicator. Rigid microphone neck with gooseneck hinge and high quality connector (MINICON Neutrik), matt black finish. Immune to Radio Frequency interference from mobile telephones, PDAs and other wireless devices operated within a conference room.
Complies with international standard IEC914
Transducer Principle
Electret condenser
Directivity
cardioid
Frequency Response
30 Hz ... 20.000 Hz
see diagram
Sensivity (free field, no load, 1 kHz)
-43 dB (0dB = 1V/Pa)
Output Impedance
1 kOhm
Max. SPL (Signal pressure level)
120 dB
Signal-to-noise Ratio
>68 dB (A-weighted, 1kHz)
Operating Voltage
5 VDC (1.5V ... 9V)
Indicator ring
colour red
Nominal current 20 mA (50 mA max.)
Connector
Neutrik Minicon
Dimensions
Total length 360 mm (300mm without connector)
dia 17.5 mm
Weight
80 g
PNW55 Windshield (included in delivery)
Also available as:
TM58/6-500 Conference Microphone 500mm,black (part no. 01.0561)
TM58/6-800 Conference Microphone 800mm, black (part no. 01.0563)
TM58/6S Conference Microphone 300mm, silver (part no. 01.0562)